- 1-4 Overview of the Capture Process. - 2 Streams Capture Process. - The Redo Log and a Capture Process. - 2-6 Capture Process Rules. - 2-19 SCN Values Relating to a Capture Process. - 2-27 Capture Process Architecture. - 2-28 Capture Process Components. - 2-29 Capture Process States. - 2-31 Capture Process Checkpoints. - 2-31 Capture Process Creation. - 2-45 ARCHIVELOG Mode and a Capture Process. - 2-46 Capture Process Parameters. - 2-47 Capture Process Rule Evaluation. - 6-63 Rule-Based Transformations and a Capture Process. - 8-6 Preparing a Database to Run a Streams Capture Process. - 9 Managing a Capture Process. - Creating a Capture Process. - 9-2 Creating a Local Capture Process. - 9-25 Starting a Capture Process. - 9-26 Stopping a Capture Process. - 9-26 Dropping a Capture Process. - Managing the Rule Set for a Capture Process. - 9-27 Specifying a Rule Set for a Capture Process. - 9-27 Adding Rules to a Rule Set for a Capture Process. - 9-28 Removing a Rule from a Rule Set for a Capture Process. - 9-30 Removing a Rule Set for a Capture Process. - 9-31 Setting a Capture Process Parameter. - 9-32 Setting the Capture User for a Capture Process. - 9-34 Setting the First SCN for an Existing Capture Process. - 14-5 Monitoring a Streams Capture Process. - 14-7 Displaying General Information About Each Capture Process. - 14-8 Displaying Information About Each Downstream Capture Process. - 15-2 Is the Capture Process Enabled. - 15-2 Is the Capture Process Current. - Chapter 2, "Streams Capture Process". - Contains conceptual information about the Streams capture process. - Chapter 9, "Managing a Capture Process". - Contains information about managing a capture process. - "Creating a Capture Process". - "Dropping a Capture Process". - A capture process can use the extracted information in the redo log to create the LogMiner data dictionary for the capture process. - "Capture Process Creation". - Overview of the Capture Process. - A capture process enqueues events into a SYS.AnyData queue. - Figure 1–2 shows a capture process capturing LCRs.. - Figure 1–2 Capture Process. - Streams Capture Process. - Capture Process Rules. - SCN Values Relating to a Capture Process. - Capture Process Architecture. - Figure 2–1 shows a capture process capturing LCRs.. - Figure 2–1 The Capture Process. - You can place these rules in a positive or negative rule set for the capture process.. - You can specify capture process rules at the following levels:. - "Capture Process Rule Evaluation". - on page 2-8 for information about the datatypes supported by a capture process. - Local capture means that a capture process runs on the source database. - Capture Process Capture. - The first SCN is needed to create a capture process.. - The applied SCN for a capture process is. - equivalent to the low-watermark SCN for an apply process that applies changes captured by the capture process.. - See "Capture Process Creation". - on page 2-32 for more information about the first SCN and start SCN for a capture process.. - Capture Process Components. - Capture Process States. - Capture Process Checkpoints. - Capture Process Creation. - ARCHIVELOG Mode and a Capture Process. - Capture Process Parameters. - Capture Process Rule Evaluation. - A capture process consists of the following components:. - The capture process (cnnn) is an Oracle background process.. - "Capture Process Parallelism". - The following capture process states are possible:. - "The LogMiner Data Dictionary for a Capture Process". - The LogMiner Data Dictionary for a Capture Process. - Chapter 9, "Managing a Capture Process". - A capture process is configured to capture changes to tables.. - A database administrator stops the capture process. - "Capture Process States". - Capture Process. - Maximum checkpoint SCN of Existing Capture Process. - SCN of Existing Capture Process. - Maximum Checkpoint SCN of Existing Capture Process. - Start SCN of New Capture Process. - New Capture Process Should Create a New LogMiner Data Dictionary. - "Capture Process Checkpoints". - Note: When you create a capture process using the. - Here, the first SCN for the new capture process corresponds to the SCN of the data dictionary build.. - "Setting a Capture Process Parameter". - Capture Process Parallelism. - Automatic Restart of a Capture Process. - See Also: "Capture Process Components". - However, the capture process number (cnnn) remains the same.. - The capture process evaluates a change against the negative rule set first. - "Capture Process Components". - Could the change pass the capture process rule sets given. - capture process rule sets?. - Chapter 2, "Streams Capture Process". - for more information about the capture process. - Capture process. - Capture with a capture process
Xem thử không khả dụng, vui lòng xem tại trang nguồn hoặc xem
Tóm tắt