« Home « Kết quả tìm kiếm

Glass substrate

Tìm thấy 10+ kết quả cho từ khóa "Glass substrate"

Preparation and characterization of photocatalytic TiO2/glymo nanocomposite films

tailieu.vn

One is the growth of TiO 2 particles and the other is Na + ion diffusion from soda-lime glass substrate into the TiO 2 layer. 9,25,26 The presence of Na is undesired in TiO 2 and it deteriorates the properties of TiO 2 . 26 A barrier layer is required in order to prevent the contact of the TiO 2 layer with the glass substrate. 26 On the other hand, in hydrothermal and reflux methods, the crystalline anatase phase of TiO 2 can be obtained when the conditions are right.

Sensitive biological detection based on Langmuir–Blodgett films prepared from diluted silica suspensions

tailieu.vn

ETPTA polymer as the backbone of the porous film on the glass surface to support the porous film is chemically bonded on the glass substrate surface.. A periodic monolayer embedded in ETPTA polymer is clearly seen on the copolymer surface.

Fabrication of highly efficient pervoskite solar cells using simple single-step solution method

tailieu.vn

Therefore, the perovskite thin films fabricated on glass substrate using single-step solution method with toluene drip were analyzed using SEM and AFM. Figures 4 shows the top-view SEM image of the fabricated CH 3 NH 3 PbI 3 perovskite thin film.

Structural, surface morphological, optical and electrical properties of InxSey thin films, an absorber layer for photovoltaic cells fabricated by M-CBD method using different variables

tailieu.vn

Glass/ In x Se y 0.03 M C.S . Glass/ In x Se y 0.05 M C.S . Glass/ In x Se y 0.07 M C.S . Using M-CBD method as one of the simple, straightforward, cheap and environmental-friendly, In x Se y thin films were successfully prepared on the glass substrate. With annealing, the composition of the phases changed, particle sizes increased, energy band gaps decreased, electrical conductivities and photoconductivies increased. In x Se y A.

Plasma polymerized linalool (ppLin): An antimicrobial and biocompatible coating

tailieu.vn

The behavior of ppLin (hydrophilic surface) was compared to clean uncoated glass surfaces (hydrophilic control). Both of the bacterial species can grow on and strongly attach to the glass substrate so that they cannot be removed from the surface by rinsing with water. However, a significant reduction of bacterial attachment was observed for ppLin films when compared to the glass controls (Figure 6).

Investigation of zinc oxide thin film by spectroscopic ellipsometry

tainguyenso.vnu.edu.vn

From the transmission spectra, one can note that the ZnO spectrum quite appears in the same transparent region of the substrate. From this spectrum one can also determine the optical band gap (E g ) of the zinc oxide film which was found to be E g ≈ 3.33 eV.. Polarized spectra of ZnO sample, with I s = sin2Ψsin∆ (a) and I c = sin2Ψcos∆ (b).. Transmittance spectra of glass substrate and ZnO film..

Introduction To Microelectromechanical System P2

tailieu.vn

The coefficient of thermal expansion of the glass substrate is preferably matched to that of silicon in order to minimize thermal stresses. In this case, the required voltage to initiate the bond process decreases to less than 100 V due to the thinness of the glass layer.. Mobile sodium ions in the glass migrate to the cathode leaving behind fixed negative charges. This can be achieved by using chemomechanical polishing, described in the following section..

Practical Arduino Cool Projects for Open Source Hardware- P15

tailieu.vn

A resistive touch screen consists of several plastic layers built on a glass substrate that provides rigidity to the whole structure. In some touch screens the resistive material is applied directly to the glass substrate to achieve the same end result. Layers in a resistive touch screen. When the front layer is touched, it distorts and makes contact with the back layer, allowing electricity to conduct from one layer to the other..

Rf Mems Circuit Design For Wireless Communications

tailieu.vn

The encounter of the <100>. atomic planes, as a result of the anisotropic etching, provided a natural stop- ping point to the process.. at four corners to the rest of the silicon wafer (Figure 3.5). of the substrate.. The second issue results from the topography of the etched pit not being metallized. The center-to-center height of the solenoid was 70 m m. Fabrication of the inductor on both silicon and glass substrates was demonstrated.

Deposition of cadmium sulfide and zinc sulfide thin films by aerosol-assisted chemical vapors from molecular precursors

tailieu.vn

After purification and characterization of these complexes, thin films were deposited on the glass substrates by AACVD. The deposited thin films exhibited good substrate adhesion and crystallinity.. The synthesis of SSPs 1 and 2 was carried out according to the reported method. The single crystal X-ray analysis of precursor 1 and 2 was carried out and cif files have been deposited in the Cambridge Crystallography Database.

Điện Tử - Thiết Bị Truyền Tin - Điện Thoại Di Dộng part 17

tailieu.vn

Glass substrate ( Hợp chất thuỷ tinh đặc biệt ) Lọc chặn điện từ các điện cực. Transparent electrodes ( Điện cực trong suốt. Là các thanh dẫn điện trong suốt cho phép ánh sáng xuyên qua. Backlighting ( Ánh sáng phía sau. Ánh sáng được chiếu từ phía sau màn hình xuyên qua các lớp trên, ở màn hình điện thoại, người ta sử dụng ánh sáng chiếu từ xung quanh sau đó dùng lớp phản xạ để hướng ánh sáng chiếu thẳng góc với màn hình từ sau về phía trước. X Electronic - Điện cực X.

Integrated on-silicon and on-glass antennas for mm-wave applications

tailieu.vn

In addition, the paper will review several on-chip antenna design on Si-substrate and also presents our latest results of on-glass antenna design and measurement. Section 2 introduces several challenges for antenna integration in mm-wave frequency regime. In Section 3, on-Si antenna and antenna array imple- mentation are presented.

Epitaxial-like Growth of Solution-processed PbZr0.4Ti0.6O3 Thin Film on Single-crystal Nb-doped SrTiO3 Substrate

tailieu.vn

Thus, fabrication of PZT thin film on Nb:STO(111) substrate by using solution process and investigating on their characteristics are studied.. The PZT thin films were fabricated on both Nb:STO(111) substrate and traditional Pt/TiO 2 /SiO 2 /Si substrate in order to make a comparison. First, PZT solution precursor was dropped uniformly on the surface of clean substrate.

Ag-decorated TiO2 nanofibers for surface-enhanced raman scattering

tailieu.vn

Figure 7 illustrates SERS spectrum of 4-MBA at five random spots over 1 x 1 cm 2 Ag/TiO 2 /glass SERS substrate. The enhancement factor (EF) of the Ag/TiO 2 substrate can be estimated by the following equation:. We chose Gaussian function in Origin software to fit peaks and used the peak area of the strongest vibration peak at 1593 cm -1 in both Raman and SERS spectrum (see Figures 5a and 5b) to obtain I SERS and I RS .

Hiệu ứng KPT Glass Lens

tailieu.vn

Với hiệu ứng Glass Lens chúng ta có thể làm việc trên cả vùng chọn hình chữ nhật và vùng chọn hình Elip.. KPT Glass Lens.. Nhấp chuột chọn hiệu ứng KPT Glass Lens 3.0 trong bộ lọc KPT 3.0 từ trình đơn Filter. Vùng cửa sổ làm việc của KPT Glass Lens xuất hiện.. Những vùng làm việc trong giao diện KPT Glass Lens. BẢNG CHẾ ĐỘ MODE. Hiệu ứng Glass Lens có 3 chế độ Mode khác nhau là Soft, Normal và Bright, có thể truy cập từ bảng chế độ Mode.. Ảnh sau đây là kết quả một trong 3 chế độ trên.

Thermoelectric property of Al-doped ZnO thin films based on solution synthesized by wet chemical reaction

tailieu.vn

It also can be seen the presence of the amorphous phase on these XRD patterns that may be due to the influence of substrate structures.. Fig.3: XRD patterns of AZO thin films on glass (a) and SiO 2 /Si substrate (b). The grain size of the AZO crystallite calculated using that equation is in range of 12 to 14 nm. The typical clusters of the coherent grains can be easily observed in these pictures.

Eye Candy 3.0 : Hiệu ứng Glass

tailieu.vn

Nh∫p ch˘ Filter Glass vËi font VNI Slogan, t≠o viÀn tr∞ng 3 pixel

Ag-grafted on ZnO nanorod arrays using UV-assisted irradiation for enhanced SERS behavior in CV detection

tailieu.vn

A significant difference between the inten- sity of signals assessed on the glass, pristine ZnO NRs, and Ag-decorated ZnO NRs platform. The Ag-decorated ZnO NRs platform exhibits the highest SERS signals among these substrates due to the syn- ergistic effects between Ag, ZnO, and R6G. No Ra- man signals of the CV molecules are recorded using the glass and the ZnO NRs substrate due to the large forbidden of ZnO NRs.

Stability and specific substrate of lipase from microbes in coconut pulp media

tailieu.vn

If the coconut pulp is used as a medium for microbial growth, it is hoped that lipase can be isolated from microbes that have a specific substrate. The purpose of this study was to determine the temperature and pH stability and lipase specific substrate from microbes that grow on coconut pulp media.. The obtained lipase is partially purified using ammonium sulfate.. fatty acids with glycerol to determine its specific substrate..

Growth and quality characteristics of spinach (Spinacia oleraceae L.) in various substrate cultures

tailieu.vn

Effects of various substrate cultures on quality characteristics of spinach. Spinach grown in both sponge and mixture of husk ash and Coconut fibre (1:1) substrates had the highest nitrate content (4050 mg/kg). Nitrate content of spinach was lowest at Coconut fibre substrate (3752 mg/kg). Total fresh weight of spinach sown on this substrate was not enough quantity to identify the quality indicators.