« Home « Kết quả tìm kiếm

Molecular weight

Tìm thấy 20+ kết quả cho từ khóa "Molecular weight"

Summary of the Doctoral Dissertation: Research on preparation of low molecular weight alginate for using functional food in preventing blood coagulation

tailieu.vn

The average molecular weight of alginate in T. The molecular weight distribution of alginate. the average molecular weight Mw. The average molecular weight meet criteria according to QCVN 4-16:. Determining the structural characteristics of sodium alginate from T. RESEARCH ON PREPARATION OF LOW MOLECULAR WEIGHT ALGINATE AND DETERMINATION OF STRUCTURAL PROPERTIES OF LOW MOLECULAR WEIGHT ALGINATE. Determination of content of low molecular weight alginate.

Purification of phytase enzyme from four selected Indian wheat varieties (Triticum aestivum L.)

tailieu.vn

The molecular weight of the purified phytase was determined by SDS- PAGE with 10% separating gel. The molecular weight of phytase bands from four selected wheat variety was 65kDa in partially purified extract as shown in Fig. Similarly, Bohn et al., (2007) reported that the molecular weight of phytase from wheat crude extract of wheat was 65kDa while lower molecular weight 47kDa was reported by Lim and Tate (1973) and 66kDa to 68kDa by Nakano et al., (1999) in wheat bran..

Tổng hợp polycaprolacton bằng xúc tác cơ magie theo phương pháp trùng hợp mở vòng =

312097.pdf

dlib.hust.edu.vn

The GPC spectrum of PCL at ratio 200:1 with the presence of BnOH The molecular weight (Mn(GPC)) measured by GPC was larger than the theoretical Mn. This result is consistent with some pervious reports that GPC measurements calibrated with polystyrene overestimate the real molecular weights of aliphatic polyesters by 50–100%, probably because the difference in hydrodynamic volume of the higher molecular weight polymers was increased (Labet & Thielemans .

Influence of soaking temperature time on the ability prepared liquefaction of wood from cashew nut shell waste

tailieu.vn

This sam- ple has a residual cashew nut shell waste ratio of 9.44%, a number average molecular weight of 7552, and a weight average molecular weight of 10640. The liquefied wood from cashew nut shell waste can be used as a binder in the manufacture of the medium density fiberboard (MDF) or as a material to promote the sintered process in the production of woodceramic materials. Key words: phenolic resin, liquefied wood, cashew nut shell waste.

Dai cuong sac ky khi

www.academia.edu

Mass spectra provide information on the molecular weight, elemental composition, if a high resolution mass spectrometer is used, functional groups present, and, in some cases, the geometry and spatial isomerism of the molecule.

POLYURETAN AMPHIPHILIC VỚI HỢP CHẤT NỐI DÀI MẠCH CHỨA POLYETYLEN GLYCOL (PHẦN I: TỔNG HỢP VÀ ĐẶC TRƯNG TÍNH CHẤT)

tainguyenso.vnu.edu.vn

The relative molecular weights and the polydispersity of the samples were calculated using a narrow molecular weight polystyrene standard calibration curve.. Synthesis of PEG-containing chain extender Ax. HN CH 2 CH 2 OH. n N CH 2 CH 2 OH. Synthesis of the PEG-containing chain extender Ax. After the extraction of the mixture with dichloromethane, the collected organic phases were dried on MgSO 4 and concentrated under reduced pressure.

23-2009 Xac Dinh KLPT Tuong Doi Cua Cac HC Bang Pp Do Nhiet Dien AP Suat Hoi

www.scribd.com

TCCS TIÊU CHU Ẩ N C Ơ S Ở TCCS 23 : 2009/PVN Xu ấ t b ả n l ầ n 1 D Ầ U M Ỏ VÀ S Ả N PH Ẩ M D Ầ U M Ỏ – XÁC ĐỊ NH KH Ố I L ƯỢ NG PHÂN T Ử T ƯƠ NG ĐỐ I C Ủ A CÁC HYDROCACBON B Ằ NG PH ƯƠ NG PHÁP Đ O NHI Ệ T Đ I Ệ N ÁP SU Ấ T H Ơ I Petroleum and petroleum products – Standard test method for relative molecular mass (molecular weight) of hydrocarbons by thermoelectric measurement of vapor pressure HÀ N Ộ I – 2009 TCCS 23 : 2009/PVN M ụ c l ụ c Trang L ờ i nói đầ u Ph ạ m vi áp d ụ ng Nguyên t ắ c ph

Nghiên cứu xác định hệ protein màng trong huyết thanh của bệnh nhân mắc hội chứng mạch vành cấp

01050001146.pdf

repository.vnu.edu.vn

Molecular &. Cellular Proteomics, 8, pp. V Proteomic mapping of brain plasma membrane proteins”, Molecular &. Cellular Proteomics, 4(4), pp. (2011), “Quantitative N-linked Glycoproteomics of Myocardial Ischemia and Reperfusion Injury Reveals Early Remodeling in the Extracellular Environment”, Molecular &. Cellular Proteomics, 10, pp. (2004), “Characterization of the Low Molecular Weight Human Serum Proteome”, Molecular &.

Synthesis and elaboration of modified comb type (maleic anhydride-α-tetradecene) copolymers for cold flow improvers of biodiesel

tailieu.vn

It can be clearly seen that the intensities of the characteristic C=O stretching peaks of the MA at 1857 cm -1 and 1778 cm -1 decrease and that of the characteristic C=O adsorption peaks of alkyl ester at 1733 cm -1 increase. (3) The viscosimetric method was used to determine the molecular weight of the MCEC copolymers. Effect of MCECs on the improvement of palm oil biodiesel cold flow (2). 1 (3) The viscosimetric method was used to determine the molecular weight of the MCEC copolymers.

Huynh Quang Phu NCKH 2021 IEEE

www.academia.edu

al, “Characterization and analysis of the molecular weight of lignin for biorefining studies”, Biofuels Bioproducts and Biorefining, vol.

Genome-wide identification, molecular evolution, and expression analysis provide new insights into the APETALA2/ethylene responsive factor (AP2/ERF) superfamily in Dimocarpus longan Lour

tailieu.vn

Identification of the AP2/ERF superfamily in longan All candidate AP2/ERF genes corresponding to the Pfam AP2 domain (PF00847) were extracted from the longan genome dataset [33]. lengths of the coding sequence (CDS), protein sequence, protein isoelectric point (pI) and molecular weight (Add- itional file 1: Table S1). Phylogenetic analysis and classification of the longan AP2/ERF superfamily.

In silico analysis of bacterial translation factors reveal distinct translation event specific pI values

tailieu.vn

Box plot diagram of pI value and molecular weight value distribution respectively of the proteins of the process of replication. Accession numbers, pI values and MW values of the proteins of replication factors.. Additional file 3: Proteins of the process of transcription. Box plot diagram of pI values, and molecular weight value distribution of the proteins of the process of transcription. Accession numbers, pI values and MW values of the proteins of transcription factors..

Bảng từ vựng tiếng anh

tailieu.vn

Lewis dot structure kết cấu điểm Lewis molecular thuộc phân tử. linear thẳng, bậc nhất, tuyến tính molecular level mức phân tử. linear hydrocarbon hi-đrô cacbon bậc nhất molecular mass khối lượng phân tử. liquid thể lỏng, chất lỏng molecular weight phân tử lượng. liter lít đơn vị đo dung tích molecule phân tử. litmus paper giấy quỳ moles phân tử gam. nuclear reaction phản ứng hạt nhân phase change sự biến đổi pha. reaction stage giai đoạn phản ứng single bond liên kết đơn. straight-chain dây chuyền

Textbook of Thermodynamics - by Paul Epstein

www.vatly.edu.vn

The geometrical variables of the system (e.g. is the molecular weight of the gas. of the (/>,iO-diagram (Fig. sists, in all cases, of the heat Q\. Several formulations of the second law. Equivalence of the formulations.. the equation (3.06) of the first law. infinitely small of the second order.. Entropy of the perfect gas. is a universal function of the reduced variables. Theory of the Joule-Thomson process. of the bracket expression (because dp/dv is negative).

Tạp chí Physics For You tháng 1/2017

www.vatly.edu.vn

(i) Maximum extension of the spring. where μ is called the reduced mass of the system defined as. where M = molecular weight of the gas As γ, R and M are constants, so v ∝ T. (i) Weight mg of the bob acting vertically downwards.. If l is the length of the simple pendulum, then θ(rad. Weight of the body,. If L is the length of the organ pipe, then. W = weight of the cylindrical cork.. W 1 = weight of the liquid displaced by the cork..

Tạp chí Physics For You tháng 12/2016

www.vatly.edu.vn

Let M mix be the molecular weight of the mixture.. where v 2 is the mean square velocity of the molecules.. N A = Avogadro's number i.e., the number of atoms in one mole of the gas.. The reciprocal of the force constant

Introduction to Nuclear Engineering (John R. Lamarsh, Anthony J. Baratta , Prentice-Hall 2001)

www.vatly.edu.vn

It is first necessary to compute the atomic weight of the uranium. The molecular weight of the V02 is then 237. W., Physics of the Atom, 4th ed. The Chart of the Nuclides. (2.3), estimate the radius of the nucleus of 238U. (d) wavelength in units of the Compton wavelength.. 2 Mc ' where M is the mass of the atom or nucleus.. What fraction of the carbon atoms i s 14C?. The thennal to electrical efficiency of the system is 5.4%. (d) the total electrical power of the generator..

Tạp chí Physics For You - tháng 01/2018

www.vatly.edu.vn

(b) The maximum acceleration of the mass is. 8 m s 2 (c) The maximum speed of the mass is. where M = molecular weight of the gas. y Hence motion of the body is SHM.. Time period of the body is given by. h 1 = length of the cylinder dipping in the liquid at equilibrium position. So the frequency of vibration of the string is. where R = 2A cos(2 mod t) is the amplitude of the resultant wave.. The amplitude R of the resultant wave will be maximum, when.

Study on the SiO2 supported ionic liquid phase (SILP) catalysts for the hydroformylation of ethylene

240970-ND.pdf

dlib.hust.edu.vn

Rhodium is the catalyst of choice for conversion of low molecular weight alkenes, while cobalt based catalysts are used for conversion of high molecular weight alkenes. For example, Ruhrchemie/Rhone-Poulenc (RCH/RP) process has been applied for hydroformylation of propene by Rh based catalysts.

Genome-wide study of pineapple (Ananas comosus L.) bHLH transcription factors indicates that cryptochrome-interacting bHLH2 (AcCIB2) participates in flowering time regulation and abiotic stress response

tailieu.vn

We further characterized the pineapple bHLH proteins based on their molecular weight, isoelectric point, amino acid, and open reading frame (ORF) length, respectively (Additional Table S1).. AcbHLH15 (Aco001136) has the lowest molecular weight of 1.04 kDa among the pineapple bHLH proteins. The pineapple bHLH proteins also have different isoelectric point values, ranging from AcbHLH30 (Aco002151) with the highest of 10.76, and AcbHLH53 recording the smallest value of 4.73.