Có 19+ tài liệu thuộc chủ đề "tín hiệu viễn thông"
tailieu.vn Xem trực tuyến Tải xuống
CHƯƠNG 1: TỔNG QUAN VỀ MÁY THU RA ĐA. Cấu hình và cấu trúc máy thu ra đa. Cấu hình máy thu ra đa. Phân loại cấu trúc máy thu. Máy thu siêu ngoại sai. Máy thu đổi tần trực tiếp. Máy thu trung tần thấp. Máy thu đa kênh dải rộng. Các yêu cầu kỹ thuật chính đối với...
tailieu.vn Xem trực tuyến Tải xuống
Figure 1.1-2 shows a number of connections in the network of Fig.. The circuit for the call consists of the subscriber lines SL, and SL,, and a temporary path in exchange A. Figure 1.1-3 shows the signaling for the set-up of the connection of Fig.. It then searches for an idle trunk in this group, and finds trunk T, Exchange...
tailieu.vn Xem trực tuyến Tải xuống
This alerted an operator, who would connect her telephone to the calling line, and ask for the called number. The operator then would connect her telephone to the called line, and ring the line. After answer by the called party, the operator would establish the connection.. Strowger (a Kansas City undertaker), of an automatic switchboard that could receive the called...
tailieu.vn Xem trực tuyến Tải xuống
The vast majority of the customers of telecommunication networks are subscribers who are attached to their local exchanges by analog subscriber lines.. The signaling between subscriber and local exchange is known as subscriber signaling [l-4]. Subscriber S1 then sends the digits of the called number, using the dial or the keypad of the telephone. The exchange can identify the called...
tailieu.vn Xem trực tuyến Tải xuống
Exchange B responds with a proceed- to-send (or wink) signal, indicating that it is ready to receive the digits of the 68. called number. Exchange C responds with a wink signal, after which exchange B sends the digits of the called number, and cuts through a path between trunks T, and TZ.. On receipt of the clear-back, exchange A stops...
tailieu.vn Xem trực tuyến Tải xuống
In channel-associated signaling (CAS) systems, the signaling information for a trunk is carried by the trunk itself. Just as multi-frequency (MF) signaling became feasible with the introduction of the second-generation (common-control) switching systems, CCS was developed for the third-generation (stored program controlled, SPC) exchanges that were introduced in the 1960s.. It is often less costly to interface the processing equipment...
tailieu.vn Xem trực tuyến Tải xuống
This chapter describes signaling system No.6, the first-generation common- channel signaling system. There are two versions of this system, both of which were first deployed in the mid-1970s. CCITT No.6 [l, 23 is still in use in the international network, on a number of transatlantic and transpacific trunk groups. Common-channel interofice signaling (CCIS), defined by the Bell System, has been...
tailieu.vn Xem trực tuyến Tải xuống
INTRODUCTION TO SIGNALING SYSTEM NO. CCITI’ began the specification of the second-generation common-channel signaling system, known as signaling system No.7 (SS7), in the mid-1970s. The system was developed initially for telephony call control, and the first recommendations were published in the CCITT Yellow Books of 1981. During the past decade, the applications of SS7 applications have expanded, and now also...
tailieu.vn Xem trực tuyến Tải xuống
In the first place, it handles the transfer of MTP-user messages across the SS7 signaling network. In the second place, it includes functions to keep the message traffic flowing when failures occur in the signaling network.. The MTP2 functions are similar to the functions of the signaling terminals in signaling system No.6 (see Section 6.1).. Figure 8.1-I SS7 signaling link.....
tailieu.vn Xem trực tuyến Tải xuống
An early version appeared in the 1980 CCITT Yellow Book. The term “telephone” dates back to the beginnings of the TUP development, when all calls were “speech” calls. The calls in the present telecommunication networks can also be used for facsimile, and other data communications. The CCITT specifications cover TUP applications in national networks, and in the international network. National...
tailieu.vn Xem trực tuyến Tải xuống
10.1.2 The Objectives of ISDN. 10.1.3 User Equipment and Access. In the U.S., the DSL and NT are considered to be outside the network, and the network-to- user interface is the U interface. 10.1.4 The ISDN Network. ISDN Network 10.1-2 ISDN network.. 10.1.6 Introduction to DSSl. 10.2 DATA LINK LAYER (LAPD). 10.2.1 Data Link Connections. Figure 10.2-l Data link connections...
tailieu.vn Xem trực tuyến Tải xuống
Par.7 Access Tra~~sport. Par.2: automatic congestion level. Par.6: calling party category. Par.1 1: event information. Par.23: transmission medium requirements.. Par.3: backward call indicators. Par.12: forward call indicators. Par.1 3: information indicators. Par.2 Automatic Congestion Level. Par.3 Backward Call Indicators. Figure 11.2-5 Format of Par.4: call reference. Par.4 Call Reference. Par.5 Called Party Number. Par.7: calling party number.. Par.1 8: original...
tailieu.vn Xem trực tuyến Tải xuống
Sections 12.7-12.9 describe signaling in theglobal system. 12.1 INTRODUCTION TO CELLULAR MOBILE NETWORKS. Figure 12.14 Cellular mobile network. 12.1 .l Definitions. Figure 12.1-3 shows the connection for a call. Figure 12.1-3 Convection between mobile (MS) and subscriber (S).. 12.1.2 AMPS Radix-frequency Channels. 12.1.3 Frequency Reuse. Figure 12.1-4 Co-c~~~~e~ ~~te~ere~ce. Figure 12.1=5 Seven-cell clusters.. 12.1-5, and is using voice channel N...
tailieu.vn Xem trực tuyến Tải xuống
13.1 DEFINITIONS AND APPLICATIONS 13.1 .l Definitions. 13.1.2 Applications. 13.2 SS7 ARCHITECTURE FOR TRANSACTIONS 13.2.1 Application Service Elements. In the CCITT/ITU-T model of signaling system No.7, each function (application) that requires remote operations has an application service element (ASE), which handles the signaling aspects for that application. 13.2-1, SP-A is an exchange equipped for two transaction types, and has two...
tailieu.vn Xem trực tuyến Tải xuống
14.1 INTRODUCTION. Figure 14.1-1 shows SCCP and its relations with the other parts of SS7. Figure 14.1-1 Position of SCCP in signaling system No.7. 14.1 .l Message Transfer Enhancements. In the first place, MTP uses the service indicator (SI) (8.8.3) in an incoming message to deliver it to the appropriate MTP user (SCCP is one of them). In the second...
tailieu.vn Xem trực tuyến Tải xuống
15.1 INTRODUCTION. Sections 15.1-15.4 of this chapter follow the CCITI’ version. Section 15.5 describes the main differences of the U.S. 15.1 .l Transactions and Remote Operations. 15.1.2 Components and Messages. 15.1.3 TCAP Interfaces. Figure 15.1-I Messages and message paths.. Figure 15.1-2 TCAP message.. 15.1.4 TCAP Messages. 15.1.5 Components. 15.1.6 Application-independence. 15.1.7 TCAP Message Sequences. END [RR-Last 2 or Invoke 31...
tailieu.vn Xem trực tuyến Tải xuống
However, Par.1 (UserID) and Par.29 (STRParameterBlock) are “constructor” DES.. Par.1 User/D. Par.2 DirectoryNumber (DN) Par.3 TrunkGroupID. Par.4 PrivateFacilityGID.. Par.2 DirectoryNumber (D/V]. Par.3 TrunkG~~uplD. Par.4 PrivateFacilityGID. Par.6 TriggerType. Par.7 CallingPartylD. Par.8 Charge/i/umber. Par.9 LATA. The contents field is coded as in Par.lO.. Par.73 CalledPart@ This represents the number of the called party, and indicates whether the calling party has requested operator...
tailieu.vn Xem trực tuyến Tải xuống
IS-MAP is discussed in Sections 17.1-17.5. 17.1 INTRODUCTION TO IS-MAP. 17.1 .l Definitions [l]. 17.1.3 Interfaces. 17.1.6 IS-MAP Operations. 17.2.1 Registration Notification. Figure 17.2-I Registration procedures.. 17.2.3 Expiration of Authorization Period. 17.2.4 Registration Cancellation. 17.2.5 MS Authentication. Figure 17.2-2 Authentication of a mobile. 17.2.6 Message Contents. The MS is identified by Par.14: MobileIdentificationNumber (MIN) and Par. 0 Par.17. 0 Par.26....
tailieu.vn Xem trực tuyến Tải xuống
Điện báo truyền chữ thực hiện việc truyền một văn bản đến địa chỉ nhận tin bằng sự biến đổi tin tức trong văn bản gốc thành tín hiệu điện dạng tín hiệu số ở phía phát. Nguyên lý: Truyền ảnh tĩnh là dịch vụ sao chép tài liệu từ xa với tốc độ cao nhờ truyền tín hiệu trên...