Tìm thấy 20+ kết quả cho từ khóa "Phosphoric acid"
tailieu.vn Xem trực tuyến Tải xuống
A beneficial effect of phosphoric acid is to inhibit the rate of the self-discharge reaction of the positive electrode in the lead/acid battery. However, adverse effects of phosphoric acid include capacity loss in the initial cycles, excessive mossing, especially at high H3PO 4 concentrations, and poor low-temperature performance (decrease in the rate of PbSO4 oxidation).
tailieu.vn Xem trực tuyến Tải xuống
A new electrolyte formulation for low cost cycling lead acid batteries. This paper is devoted to the development of a new lead acid battery electrolyte formulation for cycling applications, especially for renewable energy markets in developing countries. The new acid formulation developed is a mixture of sulphuric acid, liquid colloidal silica and other additives including phosphoric acid..
tailieu.vn Xem trực tuyến Tải xuống
This paper describes the corrosion behaviour of the positive and negative electrodes of a lead–acid battery in 5 M H 2 SO 4 with binary additives such as mixtures of phosphoric acid and boric acid, phosphoric acid and tin sulphate, and phosphoric acid and picric acid. A lead salt battery has been fabricated replacing the binary mixture with an alternative electrolyte and the above electrochemical parameters have been evaluated for this lead salt battery.
tailieu.vn Xem trực tuyến Tải xuống
Ruetschi, Review on lead±acid battery science and technology, Lead±Acid Batteries Reference and Data Book, Elsevier Sequoia, Lousanne, 1977.. premature capacity loss of lead±acid batteries, J. Meissner, Phosphoric acid as an electrolyte additive for lead±acid batteries in electric-vehicle applications, J. Vaurijoux, Effect of a special additive on the performance of standby valve-regulated lead acid batteries, J.
tailieu.vn Xem trực tuyến Tải xuống
Weight of phosphoric acid solution,. at 25 °C, g. Weight ratio between phosphoric acid. solution and mother liquor. Table 1 shows that, in all experimental cases, the yield of solid phase is quite high, reaching approximately 90. In the experiment denoted C50, at a weight ratio of 50 g of phosphoric acid solution to 100 g of mother liquor, the solid product is obtained at an yield of 92.4. slightly higher than that in the remaining experiments.
tailieu.vn Xem trực tuyến Tải xuống
The contributions of the phosphoric acid concentration (X 1.
tailieu.vn Xem trực tuyến Tải xuống
Phosphorous acid on heating at 200°C converts to phosphoric acid and phosphine:. Phosphorous acid is a moderately strong dibasic acid. Phosphorous acid is a powerful reducing agent. Mercurous chloride is reduced further by phosphorous acid to mercury on heating or on standing:. Phosphorous acid is a diprotic acid, since the hydrogen bonded directly to the central phosphorus atom is not readily ionizable.
www.academia.edu Xem trực tuyến Tải xuống
Dung dịch tartaric acid 1%. dung dịch trichloacetic acid 0,3M. dung dịch casein 2%. dung dịch ñệm Britton và Robinson (acetic acid, phosphoric acid, boric acid). dung dịch HCl 0,2N. dung dịch tyrosine 1 mM. dung dịch Folin. ðịnh lượng sản phẩm ñược tạo thành trong phản ứng bằng phản ứng màu với thuốc thử Folin, kết quả phân tích dựa vào ñồ thị chuẩn tyrosine. ðơn vị hoạt ñộ protease là lượng enzyme phân giải protein tạo thành các sản phẩm hòa tan trong trichloacetic acid tương ứng với một micromol
tailieu.vn Xem trực tuyến Tải xuống
M phosphoric acid solution (50:50, v/v) to prepare 5 µ g/mL solution.. can be skipped.. f) Th e pH of the mobile phase is adjusted to 3 by using 5 mM NaOH and 5 mM phosphoric acid solutions..
tailieu.vn Xem trực tuyến Tải xuống
IT-SOFC intermediate-temperature solid oxide fuel cell. dministration USA) PAFC phosphoric acid fuel cell. PEMFC proton-exchange membrane fuel cell. SECA Solid State Energy Conversion Alliance US R&D fuel cell program). SOFC solid oxide fuel cell. Baker A, Bance P, Brandon NP, and Girvan B (2005) Commercialising metal supported solid oxide fuel cell technology. Proceedings of the Fuel Cell Seminar. Journal of the European Ceramic Society .
tailieu.vn Xem trực tuyến Tải xuống
The pH was adjusted to 7.4 by using concentrated ortho- phosphoric acid (Merck, Munich, Germany) and a glass electrode, and the buffer was stored in a 0.5-L glass flask. ESI + LC-MS (A) and LC-MS/MS (B) spectra of S -nitrosoglutathione (GSNO). GSNO was prepared by a two-cycle freezing/thawing (–196 ◦ C/room temperature) procedure using a solution of NaNO 2 (10 mM) and GSH (10 mM) in 100 mM sodium phosphate buffer, pH 7.4. In LC-MS/MS, the precursor ion (P) [M+H.
tailieu.vn Xem trực tuyến Tải xuống
By combining accurate weights of the buffer ingredients with accurate volumes of distilled and degassed water (without further adjusting pH), the pH of the buffer solution can be controlled within narrow limits (±0.02 unit).. a Solution of 0.1 M phosphoric acid. b Solution of 0.1 M sodium monophosphate. It is common practice to adjust the buffer pH with a concentrated acid. For example, solution A2 of Table II.1 might be prepared and titrated to the desired pH with concentrated phosphoric acid.
tailieu.vn Xem trực tuyến Tải xuống
Using of butafosfan, a phosphoric acid compound in combination with cobalamin enhances the productive and reproductive performance and reduces stress responses in animals, but did not affect the seminal quality of young and fertile stallions (Penino et al., 2015). Adequate supplies of traces minerals help in improving reproductive performance (Kumar et al., 2011).
tailieu.vn Xem trực tuyến Tải xuống
Fructose was the most abundant metabolites in the bo- vine seminal fluid, followed by citric acid, lactic acid, urea, and phosphoric acid [30]. Twenty-two metabolites were structurally identified in the bull spermatozoa, regardless of fertility phenotype of the animals.
tailieu.vn Xem trực tuyến Tải xuống
In addition, chemical treatment with phosphoric acid generated higher amounts of acid groups on the carbon surface. 12 In the investigation performed by Adib et al., the influence of phosphoric acid concentration (5%. to 30%) on the characteristics of bagasse-based AC was studied. 13 Based on the satisfying efficiency of H 3 PO 4 , this material was considered as the chemical activator for activation of sugarcane bagasse in the present work.. 16 however, to the best of our knowledge, no published
tailieu.vn Xem trực tuyến Tải xuống
Many reagents for MB desorption from different adsorbents are reported in the literature, such as ethanol, acetic acid, HCl, KCl, and phosphoric acid. In order to study the regeneration of HAP/HPAM-75, a fixed mass of adsorbent was added to a fixed volume of MB dye having a concentration of 10 mg L − 1 in order to obtain a ratio between the mass of adsorbent and volume of dye equal to 1 mg mL − 1 .
tailieu.vn Xem trực tuyến Tải xuống
Table 7 (continued) Phosphoric acid and its salts E338 Phosphoric acid E339 Sodium phosphates E340 Potassium phosphates E341 Calcium phosphates E343 Magnesium phosphates E450 Diphosphates. E541 Sodium aluminium phosphate Malic acid and its salts.
tailieu.vn Xem trực tuyến Tải xuống
Khi phân c t ọ ủ ắ DNA thành các ti u đ n v , h phát hi n ể ơ ị ọ ệ ra r ng m i nucleotide c a DNA g m ba ằ ỗ ủ ồ thành ph n: m t base nit (nitrogenous ầ ộ ơ base), m t đ ộ ườ ng deoxyribose, và m t ộ phosphoric acid. T ươ ng t , RNA cho ra ự các base, phosphoric acid và đ ườ ng ribose. Các base nit (g i t t là base), thành ơ ọ ắ ph n đ c tr ng c a các nucleotide, là các ầ ặ ư ủ h p ch t ợ ấ purine và pyrimidine d vòng ị ch a nit có tính ki m.
tailieu.vn Xem trực tuyến Tải xuống
Th e column is washed with 9 mL of 50 mM phosphoric acid solution and 3 mL of 50 mM phosphoric acid solution/methanol (4:1).. Aft er drying the column under reduced pressure, the target compound and IS are eluted with 2 mL of n-hexane/ethyl acetate (4:1) containing 1 % acetic acid and evaporated to dry- ness under a stream of nitrogen..
tailieu.vn Xem trực tuyến Tải xuống
There have been many studies to fabricate wood lique- faction such as: using wood to react with polyethylene glycol/ glycerol/ polyhydric alcohol, and catalytic sul- furic acid at 150 o C to create wood liquefaction 4–6 . addition, ethylene glycol, sulfuric acid, and wood are also combined to make wood liquefaction 7–9 . Sev- eral studies have also used phenol and acid catalysts such as sulfuric acid, phosphoric acid to make wood liquefaction from the wood pulp at 120 - 180 o C 10,11 .